[Scarab]

I've been having no success getting one sequencer to change the sequence length of another; Sending CV out to the SEQ LGTH input should alter the sequence length, shouldn't it?  I have also tried GATE out and that doesn't alter it either. 

I have set the output ranges from 5v and 9v and still can't get it to work.

I'd love some guidance.

[Scarab]

Actually I figured it out but for the benefit of others; if you have your sequence length knob all the way at 16, the patch won't do anything; the SEQ LGTH will only extend the sequence length past where you have it set, so if you have it set on max it won't choose to shorten your sequence.

[dentifyindel]

I've been having no success getting one sequencer to change the sequence length of another Survival Race; Sending CV out to the SEQ LGTH input should alter the sequence length, shouldn't it?  I have also tried GATE out and that doesn't alter it either. 

I have set the output ranges from 5v and 9v and still can't get it to work.

I'd love some guidance.

For this patch to work as intended, you will need to follow these steps:
- Turn the physical `SEQ LGTH` knob down to a value less than the maximum value.
- Connect the CV signal to the "SEQ LGTH" input of the receiving sequencer.
- Adjust the CV Signal. Start with a low voltage and increase it gradually. As you increase the voltage, you will see the sequence length start to exceed your base setting. If you are using a sequencer as a CV source, make sure its output voltage range matches the input of the receiving module

[felixandream]

In fact, I sorted it out, but I thought I'd share it in case anybody else has the same problem: the patch won't do anything if the sequence length knob is set to 16. The SEQ LGTH will only lengthen the sequence beyond your setting, so even if you set it to max, it won't choose to shorten it.