[ortedtweed]

I've been having no success getting one sequencer to change the sequence length of another; Sending CV out to the SEQ LGTH input should alter the sequence length, shouldn't it?  I have also tried GATE out and that doesn't alter it either.  sprunki phase 5

I have set the output ranges from 5v and 9v and still can't get it to work.

I'd love some guidance.

I’ve run into a similar issue before, and yeah—it *should* work when you patch CV into the SEQ LGTH input, but it really depends on how the sequencer module interprets incoming voltage. Some modules only respond to discrete voltages (like stepping between set lengths), and not all accept continuous CV. Also, double-check if the SEQ LGTH input is quantized or expecting trigger/gate signals instead of steady CV. If possible, try using a stepped CV source like a sequencer or quantizer rather than smooth CV or gate alone. What module are you using specifically? That might help narrow it down.