[dentifyindel]

I've been having no success getting one sequencer to change the sequence length of another Survival Race; Sending CV out to the SEQ LGTH input should alter the sequence length, shouldn't it?  I have also tried GATE out and that doesn't alter it either. 

I have set the output ranges from 5v and 9v and still can't get it to work.

I'd love some guidance.

For this patch to work as intended, you will need to follow these steps:
- Turn the physical `SEQ LGTH` knob down to a value less than the maximum value.
- Connect the CV signal to the "SEQ LGTH" input of the receiving sequencer.
- Adjust the CV Signal. Start with a low voltage and increase it gradually. As you increase the voltage, you will see the sequence length start to exceed your base setting. If you are using a sequencer as a CV source, make sure its output voltage range matches the input of the receiving module