01-16-2025, 10:55 AM
Hello butter.
Are all 3 jumpers (red ones) in the upper positions correctly inserted?
Also, try gently push the jumpers on a side while powering. it might be the jumpers themselves are a little worn out for some reason and they don't make a good connection.
Also is very important that the square plastic protection is in place on top of the jumpers when you close again the unit. This isolate the voltage on the jumpers from the other board above. If this protection is not in position, the module won't work
J
Are all 3 jumpers (red ones) in the upper positions correctly inserted?
Also, try gently push the jumpers on a side while powering. it might be the jumpers themselves are a little worn out for some reason and they don't make a good connection.
Also is very important that the square plastic protection is in place on top of the jumpers when you close again the unit. This isolate the voltage on the jumpers from the other board above. If this protection is not in position, the module won't work
J