Hello folks,
I am new here. I´ve just recently bought my FK and few days back finally got into trying it and I encountered a problem with my DC Interface and CV/Trigger in particular. I am actually not certain, if the problem is on my side or not. When I tried to use my solenoid and sync the DC with the LFO the red indicator did not show anything. But after a while my solenoid began to heat up, so I thought that maybe there is just problem with trigger, because when I plugged the LFO into the envelope follower, it seemed to work just fine. Could the problem be somewhere inside? Or maybe I did not take into account some factor or I am just stupid as hell. I tried to do it according to some video from youtube like step by step by it did not work anyway.
Thanks for any tips
I am new here. I´ve just recently bought my FK and few days back finally got into trying it and I encountered a problem with my DC Interface and CV/Trigger in particular. I am actually not certain, if the problem is on my side or not. When I tried to use my solenoid and sync the DC with the LFO the red indicator did not show anything. But after a while my solenoid began to heat up, so I thought that maybe there is just problem with trigger, because when I plugged the LFO into the envelope follower, it seemed to work just fine. Could the problem be somewhere inside? Or maybe I did not take into account some factor or I am just stupid as hell. I tried to do it according to some video from youtube like step by step by it did not work anyway.
Thanks for any tips