Hello
I am using external starting, triggered from a Floating Point Multiclock. It works perfectly on one Sequencer (SEQ 1). But if I want to add a second or third one to start in sync it doesn't.
If I understand correctly, I could connect SOS (SEQ 1) out to START (SEQ 2) and then the SEQ 2 should start immediately. But it starts one beat (or impuls light) later.
Mode Menu 4 is lit on SEQ 1.
The set up without external starting works fine, but not with external starting.
Anyone?....
Cheers
Mike
I am using external starting, triggered from a Floating Point Multiclock. It works perfectly on one Sequencer (SEQ 1). But if I want to add a second or third one to start in sync it doesn't.
If I understand correctly, I could connect SOS (SEQ 1) out to START (SEQ 2) and then the SEQ 2 should start immediately. But it starts one beat (or impuls light) later.
Mode Menu 4 is lit on SEQ 1.
The set up without external starting works fine, but not with external starting.
Anyone?....
Cheers
Mike