[parpgender]

Hello there. I just found out that DC interface stopped working particularly when using the clicker motor which is also overheating at the same time ( the rotation motor is still functioning somehow or somewhatgeometry dash). The light is not blinking no matter what. How can I fix this failed component? Thank you!

Hi, sounds like the DC interface board or driver circuit for the clicker motor has failed, since it overheats and the indicator light no longer responds; first step is to stop powering it to prevent further damage, then check the motor separately with a bench supply to confirm if it’s still good, inspect the driver (MOSFETs, relays, capacitors) for burnt components, replace the motor driver IC or board if faulty, and if only the interface board is dead you may need to source a replacement or repair it by swapping damaged parts.