[Jackieflipflop]

Hello!
in the DC interface section,

the motor should work if:
-the switch is set to PWM
-you turn the intensity clockwise (rotation speed will increase)

the solenoid should work if:
-the switch in the DC INTERFACE section is set o PULSE
-you patch a cable in the CV/TRIG from the LFO OUT (Waveform in pulse/square mode).
-you turn the intensity clockwise (intensity of the solenoid travel will increase)


If this is not the case, then something is not functioning properly. In that case is better to reach the support.

JJ